4.Software Configuration
386
triggers.
2. PCL interpreter:
It can detect PS triggers in PCL data. If a PS trigger is detected, the PCL interpreter will abort processing and
return the unprocessed part of the job back to the printer system. Up to 256 bytes from the start of each page
can be searched for triggers.
3. PS interpreter:
It can detect PCL5 triggers in PS data. If a PCL trigger is detected, the PS interpreter will abort processing
and return the unprocessed part of the job back to the printer system. The entire page (regardless of the
number of bytes) is searched for triggers.
• 2. and 3. can be disabled using Printer Bit Switch 2-3=1.
• If the "Printer Language" is configured to anything other than Auto, all detection will be disabled.
• An interpreter submits a job page by page to the rasterizer. Therefore, when an interpreter detects a
trigger mid-job, the previous pages will have already been submitted and will be output using the
previously detected PDL.
• If the PDL cannot be detected by the printer system, then the PDL defaults to the one configured in
"Configuration > Printer Basic Settings > Default Printer Language".
The Printer Language setting and Default Printer Language setting in WIM:
PDL selection and switching
3 types of PDL selection/switching are performed:
To Next Page
Loading...
Need help?
General
