Mainframe Installation
45
3. Open the front cover.
4. Remove the inner cover [A] ( × 1) and then store the decal in the area [B].
Settings Relevant to the Service Contract
Change the necessary settings for the following SP modes if the customer has made a service contract.
• You must select one of the counter methods (developments/prints) in accordance with the contract
(SP5-045-001).
Counting method
SP No. Function Default
SP5-045-001 Specifies if the counting method used in meter charge mode is based on
developments or prints.
NOTE: You can set this one time only. You cannot change the setting after you
have set it for the first time.
"1":
Prints
Service Tel. No. Setting
SP No. Function Default
SP5-812-001 SP5-812-002 programs the service station fax number. The number is printed on -
To Next Page
Loading...
