4.Troubleshooting
59
192.168.0.102: Failed error:XX (XX indicates an error code.)
192.168.0.103: Not connected
Error codes
The meanings of error codes recorded after "error:" in the result file are as follows:
Error codes recorded during firmware update
Error code Explanation Access Log
-2 Invalid file Recorded
-3 The target application cannot be found. Recorded
-501 Installation has already been requested. Recorded (*1)
-602 Invalid signature Recorded
-603 Updating is prohibited. Recorded
-604 Failed to put the application offline. Not recorded
-610 Authentication failed. Not recorded
-699 Unknown error Recorded (*2)
-701 Version of the micro computer firmware is invalid. Recorded
-709 File structure error (invalid file) Recorded
-710 Writing failure Recorded
Error codes recorded during application update
Error code Explanation Access Log
-2 Invalid file Recorded
-3 The target application cannot be found. Recorded
-4 The storage capacity is not enough. Recorded
-12 The version of the Android application cannot be installed. Recorded
-602 Invalid signature Recorded
-603 Updating is prohibited. Recorded
-604 Failed to put the application offline. Not recorded
-610 Authentication failed. Not recorded
-699 Unknown error Recorded (*2)
*1 The error code recorded in the Access Log will be "223: machine-busy".
*2 If the error occurs during preparation for configuration change, it will not be recorded in the Access Log.
• If the preparation for configuration change (putting the application offline, authentication, file size
check) cannot be carried out, an error code is displayed on the screen. However, it is not recorded in the
Access Log as a firmware update/installation error.
To Next Page
Loading...
