Controller Options
131
• The SD card can be the only proof that the user is licensed to use the application program.
• You may need to check the SD card and its data to solve a problem in the future.
Move Exec
"Move Exec" (SP5-873-001) lets you move application programs from the original SD card to another SD card.
• Do not turn ON the write protect switch of the system SD card or application SD card on the machine.
If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a firmware
update or application merge.
1. Turn OFF the power.
2. Remove the SD card slot cover [A].
3. Make sure that a target SD card is in SD card slot 1 (upper). The application program is moved to this SD
card.
4. Insert the source SD card with the application program in SD card slot 2 (lower). The application program
is copied from this source SD card.
5. Turn ON the power.
6. Enter the SP mode.
7. Select SP5-873-001 "Move Exec".
8. Follow the messages shown on the operation panel.
9. Turn OFF the power.
10. Remove the source SD card from SD card slot 2 (lower).
11. Attach the slot cover.
12. Turn ON the power.
13. Check that the application programs run properly.
Undo Exec
"Undo Exec" (SP5-873-002) lets you move back application programs from an SD card in SD card slot 1
(upper) to the original SD card in SD card slot 2 (lower). You can use this program when, for example, you have
mistakenly copied some programs by using Move Exec (SP5-873-001).
To Next Page
Loading...
