PM/Yield Parts Settings
171
3.Press [EXECUTE] to output the PM counter list.
4. Press [Exit].
3.
In the SMC data, check the values of the counters in SP7-621-002 to 208, to determine what parts should
be replaced. (Refer to the SP table in the appendix.)
4. Set the following SPs (New Unit Detection) to "1" to reset the PM counter.
Item SP
Fusing sleeve belt assembly SP3-701-116
Pressure roller SP3-701-118
ITB unit SP3-701-093
Paper transfer roller unit SP3-701-109
Waste toner bottle
(When the bottle is replaced BEFORE a waste toner full or near-full message
appears)
SP3-701-142
Tray paper feed Feed roller:SP3-701-147
Friction pad: SP3-701-148
Bypass feed roller SP3-701-169
ADF Friction pad: SP3-701-206
Pickup roller:
SP3-701-207
Feed roller: SP3-701-208
Toner transport section K: SP3-701-220
To Next Page
Loading...
