Card Save Function
406
Card Save Function
Overview
Card Save:
• The Card Save function is used to save print jobs received by the printer on an SD card with no print
output. Card Save mode is toggled using printer Bit Switch #1 bit number 4. Card Save will remain
enabled until the SD card becomes full, or until all file names have been used.
• Captures are stored on the SD card in the folder /prt/cardsave. File names are assigned sequentially from
PRT00000.prn to PRT99999.prn. An additional file PRT.CTL will be created. This file contains a list of all
files created on the card by the card save function.
• Previously stored files on the SD card can be overwritten or left intact. Card Save SD has "Add" and
"New" menu items.
• Card Save (Add): Appends files to the SD Card. Does not overwrite existing files. If the card
becomes full or if all file names are used, an error will be displayed on the operation panel.
Subsequent jobs will not be stored.
• Card Save (New): Overwrites files in the card's /prt/cardsave directory.
Limitation:
• Card Save cannot be used with PJL Status Readback commands. PJL Status Readbacks will not work. In
addition they will cause the Card Save to fail.
Procedure
1.
Turn OFF the power.
2. Insert the SD card into slot 2 (lower), and then turn ON the power.
3. Enter SP mode.
4. Select the [Printer SP].
5. Select SP1-001 (Bit Switch).
6. Select "Bit Switch 1 Settings" and use the numeric keypad to turn bit 4 ON and then press the "#" button to
register the change. The result should look like: 00010000. By doing this, Card Save option will appear in
To Next Page
Loading...
