3. Push the multi bypass banner sheet tray into its original position.
Loading Paper into the Banner Sheet Guide Tray
The banner sheet guide tray can be attached to the wide LCT. This allows you to load paper having a
horizontal dimension of 487.8 mm (19.21 inches) or greater in the bypass tray.
• When you open the bypass tray when a banner sheet guide tray is installed, do not put your
hands on the front side and the back side of the place indicated by the label of the banner sheet
guide tray. Otherwise, your fingers might be caught, resulting in injury.
1. Open the bypass tray.
Be careful not to get your hand caught between the bypass tray and banner sheet guide tray.
2. Release the locks on both of the paper guides.
Move the paper guides in the same way as when loading paper in the bypass tray.
page 207 "Loading Paper into the Bypass Tray"
Loading Paper into the Paper Tray
213
To Next Page
Loading...
