Ricoh Pro C5310S - When Ejecting Carbonless Paper Weighing 63 G;M or Less to Finisher Sr5110;Booklet Finisher SR5120

3. Attach the thin paper support tray by fitting its protrusions in the slots on the finisher.
D0CPIC1773
4. Press the [Suspend / Resume] key to resume printing.
When Ejecting Carbonless Paper Weighing 63 g/m
2
or Less to Finisher
SR5110/Booklet Finisher SR5120
When printing on carbonless paper weighing 63 g/m
2
or less, set the banner support tray that is
provided with the finisher on the finisher shift tray.
1. Press the [Suspend / Resume] key on Finisher SR5110 or Booklet Finisher SR5120, and
then remove the delivered paper.
page 38 "Removing Prints from Finisher SR5110/Booklet Finisher SR5120 during Printing or
When in Standby State".
2. Pull out the extension tray on the finisher shift tray 1 or 2.
D0CIPC1772
Special Notes When Using External Options
45