Ricoh Pro C5310S - Loading Tab Stock into the Multi Bypass Tray (Tray A)

3. Press the elevator switch on the multi bypass tray (Tray A).
D0CPIC1380
The lamp of the elevator switch is blinking while the tray is going up, and keeps lit when it stops.
Press the elevator switch to move down the tray if you want to either add paper or remove jammed
ones.
4. Specify the paper settings.
page 289 "Overview of Paper Settings"
• Pull the extender out when loading A4 , 8
1
/
2
× 11 or larger sheets in the multi bypass tray
(Tray A).
• Letterhead paper must be loaded in a specific orientation.
• page 281 "Loading Orientation-fixed Paper or Two-sided Paper"
• You can load envelopes into the multi bypass tray (Tray A). Envelopes must be loaded in a specific
orientation.
• page 277 "Envelope Orientation and Recommended Status"
• Specify the sizes of paper that are not automatically detected.
• page 238 "Specifying the Paper Size That Is Not Automatically Detected"
Loading tab stock into the multi bypass tray (Tray A)
When setting tab stock, always use the tab fence. Tabs must be set at the right side of the multi bypass
tray (Tray A).
Specify the paper settings before you start printing.
page 289 "Overview of Paper Settings"
8. Paper Specifications and Adding Paper
216