When data transmission fails
Message Cause Solution
"Transmission has failed.
To check the current
status, press [Scanned
Files Status]."
While a file was being
sent, a network error
occurred and the file
could not be sent
correctly.
If the same message appears again after
scanning again, the cause could be a mixed
network, or network settings were changed
during WSD scanner transmission. For details
about network error, contact your
administrator.
When data cannot be sent because a currently used file is selected
Message Cause Solution
"Selected file is currently
in use. File name cannot
be changed."
You cannot change the
name of a file whose
status is "Waiting...".
Cancel transmission ("Waiting..." status
cleared), and then change the file name.
"Selected file is currently
in use. Password cannot
be changed."
You cannot change the
password of a file
whose status is
"Waiting...".
Cancel transmission ("Waiting..." status
cleared), and then change the password.
"Selected file is currently
in use. User name cannot
be changed."
You cannot change the
sender's name whose
status is "Waiting...".
Cancel transmission ("Waiting..." status
cleared), and then change the user name.
"Some of selected files
are currently in use. They
could not be deleted."
You cannot delete a file
which is waiting to be
transmitted ("Waiting..."
status displayed).
Cancel transmission ("Waiting..." status
cleared), and then delete the file.
11. Troubleshooting
418
To Next Page
Loading...
