Technical Bulletin PAGE: 1/2
Reissued:30-Aug-13
Model: Aries-P1.5/C1.5 Date: 22-Mar-12 No.: RM077068a
RTB Reissue
The items in bold italics were added.
Change: New BRUSH ROLLER:APPLY:ASS'Y
Reason: To prevent the image quality issue known as “Vertical lines” caused by excess
lubricant applied to the OPC drum
Action: If you encounter the above image quality issue, replace the brush roller with the
new brush roller described below.
Old Part
Number
New Part
Number
Description Q’ty Int Page Index Note
GD042011 GD042012
BRUSH ROLLER:APPLY:ASS'Y 1 O/O 97 16 Change
NOTES:
When replacing with the new brush roller (GD042012), make sure to remove the
“paper clips”, if installed, from the previous brush roller.
The new brush roller should be replaced only for units with the drum cleaning
unit registered with the p/n M0773600. This is because the modified drum
cleaning unit (M0773601) has the new brush roller. (See the following page.)
The new brush roller applies the optimum amount of lubricant, preventing
vertical lines as a result of excess lubricant on the drum.
Subject: Part Changes –For vertical lines Prepared by: H. Kawamura
From: 1st PP Service Planning Sec., PP Service Planning
Classification:
Troubleshooting
Mechanical
Paper path
Product Safety
Part information
Electrical
Transmit/receive
Other ( )
Action required
Service manual revision
Retrofit information
Tier 2
GD042011 GD042012 (Change)
BRUSH ROLLER:APPLY:ASS'Y
To Next Page
Loading...
