Technical Bulletin PAGE: 1/7
Model: Aries-P1.5/C1.5 Date: 04-Nov-11 No.: RM077049
Subject: PCDU Slide-rail Rework Prepared by: J. Kobayashi
From: 1st Tech Service Sect., PP Tech Service Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Product Safety Other ( ) Tier 2
Symptom
Slide-rail could drop from the Stay when setting the C, M, and Y development units.
Cause
Mold used for creating the Stay was damaged and fixed but the dimensions of the fixed mold were incorrect.
OK
Stay with
the correct
dimensions
NG
Stay with
incorrect
dimensions
The mold used for Black is separate from the other colors, and therefore, the problem occurs only with the
Stays (positioned to the right hand side viewed from the front) for Cyan, Magenta, and Yellow.
Slide-
ail
The Slide–rail is not
latched with the Stay.
The tip of the stay is
hanging on the
projection.
The projection on the Slide-
rail is not latched to the
hole in the Stay.
7.58~7.68mm
7.9mm
8.18mm
Stay - Hole
7.9mm
The projection on the
Slide–rail fits properly in the
hole in the Stay.
This figure shows the 2
components latching
properly.
Sta
Slide-
ail
Slide-rail -
Projection
Stay - Hole
Slide-rail -
Projection
To Next Page
Loading...
