Technical Bulletin PAGE: 2/7
Model: Aries-P1.5/C1.5 Date: 04-Nov-11 No.: RM077049
Solution
Replace the current slide-rails with the modified slide-rails for C, M, and Y stations either on new installs or a
service visit for the affected units shown on the following page.
NA
The modified slide-rails are either attached to the mainframe as an accessory or have already been shipped
to the local service stations.
RE / Asia
Procure the modified slide-rails by referring to the information below.
Part Number Description Remark
M0779901 SLIDE RAIL:DEVELOPMENT UNIT 3 pcs required per unit
Details of the Modified Slide-rail
The hole in the Slide-rail was enlarged to allow the latch on the Stay to reach the projection.
NOTE 1
The modified slide-rails are indicated with a white marking.
NOTE 2
Instead of modifying the Stay which had the incorrect dimensions, the Slide-rails were modified because
replacement of the Stay is complex and is inappropriate to carry out in the field. Replacement with the
modified Slide-rails will have no adverse affect on the durability of the Stay and enables proper latching of
the two components.
White Marking
0.4 ~0.5mm
Hole in the slide-rail was
enlarged 0.4~0.5mm.
Cyan
Magenta
Yellow
Replace the 3 slide-rails installed
in the right hand side of Cyan,
Magenta, and Yellow stations.
To Next Page
Loading...
