Technical Bulletin PAGE: 1/1
Model: Aries-P1.5/C1.5 Date: 08-Nov-10 No.: RM077009
Subject: Change the PM Yield of Fusing Belt Prepared by: Hiroaki Matsui
From: PPBG Service Planning Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Product Safety Other ( ) Tier 2
GENERAL
As mentioned in the service manual, the PM yield of the fusing belt is prescribed as 400k.
However, the operation panel indicates the yield of 800k.
SOLUTION
F/W will be modified to indicate the correct PM yield of 400k.
For a temporary solution until the fixed f/w is released, please change the value from 800k
to 400k in SP7951-118 (Page Counter:End Std Value Fusing Belt) when installing the
machine on-site.
To Next Page
Loading...
