Technical Bulletin PAGE: 1/6
Reissued:09-May-13
Model: Aries-P1.5/C1.5 Date: 06-Mar-13 No.: RM077087a
RTB Reissue
The items in bold italics were corrected or added.
This RTB has been issued to announce the requirements for upgrading the Pro C901
Graphic Arts Edition to the Pro C901 Graphic Arts +.
The following are the requirements for the above upgrade:
1. ProC901 needs to be run by a Fiery E-42 or E-82 controller
Note 1: E-41/E-81 cannot be upgraded to E-42/E-82
Note 2: An announcement will follow for the upgrade procedure on ProC901
Graphic Arts + for units run by a Creo C-81 controller.
2. Installation of ALL countermeasure parts released for image quality issues
(See the following pages for details.)
3. Changing the max supported paper weight from 300gsm to 350gsm via f/w upgrade and
SP modification
(See the following pages for details.)
4. Usage of the new toner bottle and SP modification
(See the following pages for details.)
NOTE
The rating plate will not change for the upgraded units because the plates can only be
attached at the factories (Katsuta, REI, RPL).
IMPORTANT
Make sure to keep records of the customer names and mainframe s/n for the units that
completed the upgrade.
Subject:
Upgrade to Pro C901 Graphic Arts + Prepared by: T. Miyamoto
From: 1st PP Tech Service Sec., PP Tech Service Dept.,
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Classification:
Product Safety Other ( ) Tier 2
To Next Page
Loading...
