Technical Bulletin PAGE: 6/9
SOLUTION for Symptom 2
1. Enter the Advanced Setting Menu and specify the line speed according to the paper
weight/type in #16: Fusing Feed Speed Adj. by referring to Table 1 below.
2. Is the value set in #16: Fusing Feed Speed -1.5% or higher?
(For example, -1%, -0.5%, etc.)
Yes : Do step 3.
No : Finished. No further adjustments available because of the machine specs.
3. Print the affected image and check if the results are accepted by the customer.
Yes : Do step 4.
No : Do step 5.
4. Set SP1107-034 (Idle Time: After Reload) to 20 (default: 7) to complete the procedure.
NOTE: This SP modification is intended to decrease the fusing line speed until the
pressure roller temperature becomes stable after turning on the machine power.
5. Enter the Advanced Setting Menu and decrease the fusing speed 0.5% in #16: Fusing
Feed Speed Adj to improve fuseability.
(For example, if the current value is -1%, enter "-1.5%" to decrease the speed 0.5%).
Then repeat step 2 and complete the procedure at either step 2 or 4. Note that “-1.5%”
is the lower limit of the fusing speed.
Non-coated Matte-coated Gloss-coated
Thick 2 64~80.0 0.0% 0.0% 0.0%
Thick 3 80.1~105.0 0.0% 0.0% 0.0%
Thick 4 105.1~163.0 -0.3% -0.3% -0.5%
Thick 5 163.1~220.0 -0.7% -0.7% -0.6%
Thick 6 220.1~256.0 -0.9% -0.9% -0.8%
Thick 7 256.1~300.0 -1.2% -1.2% -0.9%
Table 1: Fusing feed speed adjustment
To Next Page
Loading...
