Ricoh SP 3710DN - Page 128

5.System Maintenance
116
Menu
Description
Thick
Vert. Bypass
Thin
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Horiz. Dup.
Back
[-40.0 to 40.0 / 8.0 (Default) / 0.1 mm/step]
Vert. Dup.
Plain
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Dup.
Thick
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Dup.
Thin
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Reset Transfer Unit
Clears the EM counter of the transfer roller.
Reset Fuser Unit
Clears the EM counter of the fusing unit.
Fuser SC Reset
This menu is for resetting an SC related to a fusing error.
2 Beam LD Power
Adjusts the LD power.
[74 to 137 / 106 (Default) / 1/step]
Interval Setting
Corrects the face curl of paper.
0: OFF (32ppm)
1: Sets the engine speed to half after printing 1 minute.
2: Sets the engine speed at 13ppm.
[0 to 2 / 0 / 1 /step]
Toner Near
End To End
Sheets
Adjusts the printable sheets between "toner near end" and "toner
end".
[50 to 250 / 200 / 25 sheet/step]
Dot Count
Adjusts the printable dot count between "toner near end" and "toner
end".
[50 to 150 / 100 / 25 dot/step]
Trans. Roller Bias
Adjusts the transfer roller bias.
[-6 to 6 / 0 / 1/step]
Developer Bias
Adjusts the developer bias.
[270 to 330 / 250 / 15/step]
Charge Bias
[1100 to 1300 / 1200 / 25/step]
Fusing Unit
Temperature
Plain Paper
Adjusts the fusing temperature for plain paper.
[150 to 200 / 175 / 1°C/step]
Recycled
Adjusts the fusing temperature for recycled paper.
[160 to 180 / 170 / 1°C/step]
Postcard
Adjusts the fusing temperature for postcards.