Ricoh SP 3710DN - Paas Registration

3.Setting for PaaS (Only for CHN)
14
PaaS Registration
Make sure the machine’s main power is always turned on and connected to the internet during
registration.
1. Launch the web browser.
2. In the web browser’s address bar, enter http://(machine’s IP address)/ to access the machine.
3. On the Web Image Monitor menu, select NPB Settings.
4. Check that [Operation] is set to "Contract Registration".
Operation List:
Item
Description
Contract Registration
Select this to enter the ID and Authentication Key after registration.
Contract Status Checking
Select this if the machine stops operating.
The machine asks the server about the registration status.
Contract Cancellation
Select this to cancel the registration.
Device Replacement
Select this to replace the machine being used.