Ricoh SP 3710DN - Page 134

5.System Maintenance
122
Menu
Description
Stop/Clear Key
Pressing the Stop/Clear key can stop the current receiving
operation. Received data is lost.
[No Functional (Default)/ Functional]
Off-Hook
Detection
Sets the Off-Hook detection period.
[200 msec (Default)/ 800 msec]
Number for
Remote Switch
[0～9 / 2 (Default/ 1digit/step]
Number of time
to press
[1～3 / 2 (Default/ 1time/step]
Period: TEL to
Fax
[Limitless / 10 sec (Default/ 20 sec / 30 sec / 40 sec]
TX Settings
Redial Interval
Sets the redial interval when Tx fails.
[5 Min (Default)/ 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times (Default)/ 3 Times/ 4 Times/ 5 Times]
Overseas
Comm Mode
Settings
Overseas
Comm Mode
This sets the machine to ignore a DIS signal sent from the called
station once in a sending operation.
[Off (Default)/ Ignore DIS Once]
Minimum Time
Length
If this setting is set to "On", the machine detects the CNG signal
after the line is connected. If it is set to "Off", the machine
detects the CNG signal as long as the line is connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
Dial Pulse
Setting
Dial Pulse Type
This sets the number of pulses that are generated during dialing.
 N: Dialing '0' generates 10 pulses --- Dialing '9' generates 9
pulses. (Default)
 N+1: Dialing '0' generates 1 pulses --- Dialing '9' generates
10 pulses.
 10-N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 1 pulse.
Tone Signal
Settings
Tone Signal
Transmission T
Sets the tone signal transmission time length
[100 ms (Default)]
Minimum Pause
In Tone Dial
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Attenuator of
Pseudo Ring
Sets the attenuator for pseudo ringback tone to the line
[0 to 15 / 10 (Default)/ 1 dB/step]
DTMF Level
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu (Default)/ -8 dBu/ -6 dBu]