3.Setting for PaaS (Only for CHN)
19
1. Launch the web browser.
2. In the web browser’s address bar, enter http://(machine’s IP address)/ to access the machine.
3. On the Web Image Monitor menu, select NPB Settings.
4. Check that [Operation] is set to "Device Replacement".
Operation List:
Select this to enter the ID and Authentication Key after registration.
Select this if the machine stops operating.
The machine asks the server about the registration status.
Select this to cancel the registration.
Select this to replace the machine being used.
5. Check and enter [Contract ID], [Authentication Key], and [NPB URL].
Registration Configurations List:
To Next Page
Loading...
