RIGOL
User’s Guide for DM3058
Example 7: Reading Hold
Reading Hold can help user to obtain a stable reading and hold it on the display of
Front Panel. The reading would be hold all the same although testing pen had been
withdrew.
Operating Steps:
1. Connecting the red lead (Test leads) to Terminal Input-HI (tested circuit) and
black lead to Terminal Input-LO.
2. Press to start DC Voltage Measurement and choose an appropriate
range.
3. Set Parameters of Holding Trigger.
(1) Press Auto Hold On/Off 0.1% ，Holding range:
0.1%
Figure 3-27 Reading holding interface
(2) Press to save all changes.
(3) Repress to finish setting and close menu.
4. Press two times to start Hold function.
5. Connecting Test leads into circuit and start measuring.
To Next Page
Loading...
