Rigol DM3058

RIGOL
User’s Guide for DM3058
2-52
External Triggering
is used to set the parameter which initiates the trigger function. It requires
setting the following parameter: the Rise edge, the Fall edge, HiLev (high level)
and LoLev (low level). Press Done to start the external triggering, the keys
and on the front panel will be off to indicate the instrument using external
triggering mode.
Press  Ext, the display shows:
Figure 2-70 The Interface of the External Triggering
Table 2-24 Function Menu of External Triggering
Function
Menu
Settings
Explanation
Rise
Set the External Trigger Mode as
Rising Edge.
Fall
Set the External Trigger Mode as
Falling Edge.
Hi Lev
Set the External Trigger Mode as
High Level.
Lo Lev
Set the External Trigger Mode as
Low Level.
Save all the changes and go back
to last menu.
1. To run External Trigger
After setting the parameter, press to go back to last Manu and run
External Trigger by pressing Done . Now, and on the Front Panel
will be crushed out, the instrument enter into the External Trigger Mode.