Rigol DM3058

RIGOL
User’s Guide for DM3058
2-51
Single Triggering
The multimeter takes one reading, or a number of readings specified by a sample
count you enter, each time press.
Press  Single to enter into the following interface. Then Input needed sample
counts by Directive keys. After setting please press Done to open Single Trigger, at
this time Done is hiding and is lighten.
Figure 2-69 Parameter settings of Single Trigger
Sample Count
 Sample Count indicates the count of point have been sampled while the
instrument get a signal of Single Trigger.
 The range of sampling point should be between 1 and 1000.
 The default of Sample Count is 1.