Rigol DM3058

RIGOL
User’s Guide for DM3058
2-59
I/O Settings
Each device on the GPIB (IEEE-488) interface must have a unique address between
0 and 30. The factory set is “1” when shipped.
Press  I/O, the display shows:
Figure 2-79 Interface Setting
Table 2-28 I/O Setting Function Menu Description
Function
Menu
Settings
Description
LAN
Set up LAN interface.
GPIB
Set up GPIB I/O interface. The bound of
value is 0~30.
USB
Check USB interface ID.
RS232
Set up RS-232 I/O interface.
Save all changes, back to a higher level
menu.
Operation introduction:
Remote control through LAN, GPIB (IEEE-488), USB and RS-232 interface can
be configured. The I/O interface of GPIB, USB and RS-232 only one could be
used at the same time.