RIGOL
User’s Guide for DM3058
To Set Up Trigger Parameters
The optional Trigger methods of DM3058 include Manual Trigger, Single Trigger and
Exterior Trigger. The default trigger mode is Auto.
Press to capture continuous readings automatically. If you repress it once
more, a stable reading will be captured and hold.
Press , Single Trigger will be generated on time, and an effective reading will be
captured.
Press to set parameters for every trigger. In the following interface of
Parameter setting, after you select Auto 、 Singe 、 Hold or VMC on the menu,
the current trigger mode shown in the parameter area will be changed accordingly
and display relative parameter for current trigger.
Figure 2-66 Interface of triggering parameter
Table 2-21 Function Menu of triggering parameter
Setting system Auto trigger and reading Hold meter
reading measurement schemes.
Setting Single manual trigger parameter.
Setting external triggering.
Setting the output signal pulse width at sampling
ending output signal.
Save all changes, back to a higher level menu.
To Next Page
Loading...
