RIGOL
User’s Guide for DM3058
To Set up Measurement Parameters
Press to set measurement parameters for DC Voltage, DC Current and
Continuity via its Operation menu.
The parameters have been configured when the multimeter leaving factory. So you
can either measure directly or edit them to meet your requirements. The
Measurement parameters Menu includes: Conti, Filter, Rel, Null, and Ratio.
AC Filter
AC Filter is applicable for measuring DC Voltage and DC Current.
While either DC Voltage or DC Current Function is selected, press Filter,
enter the menu shown below. If AC hefts existing in measured DC signal, you can
strain them off by AC Filter so as to make the data more exactly.
Figure 2-57 Open/Close AC Filter
To Next Page
Loading...
