RIGOL
User’s Guide for DM3058
Table 2-7 Capacitance Measurement Characteristics
2nF, 20nF, 200nF, 2μF, 200μF、10000μF
1000V on all ranges (HI Terminal)
NOTE*: All the ranges enable to obtain 20% ranges higher than original;
Besides, both Manual and Auto are available for setting every range.
4. Set Relative Value ( Optional)
Press REL to open or close Relative math function. When it is open, “REL” is
shown over the screen and the reading displayed is a relative value which
comes from the result of Actual measurement vale reduces selected value.
(For the details about how to set, please refer to” Math” in Chapterer2.)
5. View History data.
6. View History data
Press History to enter into the following interface and check the data getting
from this measurement and save.
Figure 2-25 View interface of History information
There are three types of way for viewing historical date: “Info”,” List” and “HistoG”.
Press Save after checking. By pressing Update, the History information will be
refreshed to be current newest information.
NOTE
Before measuring the electrolytic capacitance, you should make the two
legs of the electrolytic capacitance short circuit and let it be discharged.
To Next Page
Loading...
