RIGOL
User’s Guide for DM3058
Continue Resistance
Set up the continue resistance value in the short test menu. When the measured
resistance is below P/F, the DM3058 will beep to indicate the circuit continuation.
The continue resistance is only using at Continue Test.
Press Conti, enter the menu shown below:
Figure 2-59 Set up the continue resistance
Use directive keys to change the parameter values:
Press left and right directional keys to choose different digits. Press up and down
keys to change the current digit value.
Continue Resistance
The range of continue resistance is 1Ω~2000Ω. The default value is 10Ω.
The continue resistance value stored in the nonvolatile memory, the
resistance still keep when the power is off.
To Next Page
Loading...
