Rigol DM3058

RIGOL
User’s Guide for DM3058
2-63
3. Set Up RS-232 I/O Parameters
Choose RS-232 (serial data interface) interface. Proper configure the baud rate and
parity to make parameters the same as that settled in your computer. Make sure
the connection line is unbroken. The configuration is saved in inviolate memory and
shown in according menu.
Press  I/O  RS232, enter the menu shown below:
Figure 2-83 RS-232
Table 2-31 RS-232 Parameter Function Menu Explanation
Function
Menu
Settings
Explanation
Baud
1200
2400
4800
9600
19200
38400
57600
115200
Set RS-232 band rate
Parity
None
Odd
Even
The parity check include: None,
Odd check, and Even check.
Save all changes, back to a higher
level menu.
Baud rate:
Proper configure the baud rate and parity to make parameters the same as that
settled in your computer.
Available baud rate values are 1200, 2400, 4800, 9600, 19200, 38400, 57600 and
115200. The default value is 9600.
Parity:
Proper configure the parity to make it same as that settled in your computer. There
are three parameters: None、Odd、Even, the default is “None”. The current choice is
stored in nonvolatile storage.