Rigol DP832A - System:communicate:gpib:address; System:communicate:lan:apply; System:communicate:lan:autoip[:State]

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-53
:SYSTem:COMMunicate:GPIB:ADDRess
Syntax :SYSTem:COMMunicate:GPIB:ADDRess <gpibaddress>
:SYSTem:COMMunicate:GPIB:ADDRess?
Description Set the GPIB address.
Query the current GPIB address.
Parameter
Name Type Range Default
<gpibaddress> Integer 0 to 30 2
Explanation Before using the GPIB interface, extend a GPIB interface using the USB-GPIB
interface converter; then, connect the instrument and PC using GPIB cable and set
the GPIB address.
Return Format The query returns an integer, for example, 7.
Example :SYST:COMM:GPIB:ADDR 7
:SYST:COMM:GPIB:ADDR?
:SYSTem:COMMunicate:LAN:APPLy
Syntax :SYSTem:COMMunicate:LAN:APPLy
Description Apply the network parameters currently set.
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]
Syntax :SYSTem:COMMunicate:LAN:AUTOip[:STATe] {ON|OFF}
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]?
Description Enable or disable the auto IP configuration mode.
Query the status of the auto IP configuration mode.
Parameter
Name Type Range Default
{ON|OFF} Bool ON|OFF ON
Explanation  In auto IP configuration mode, the instrument acquires the IP address from
169.254.0.1 to 169.254.255.254 and subnet mask 255.255.0.0 according to
the current network configuration automatically.
 When all the three configuration modes are set to “On”, the priority order of
parameter configuration is “DHCP”, “AutoIP” and “ManualIP”.
 The three IP configuration modes cannot all be set to “Off” at the same time.
Return Format The query returns ON or OFF.
Example :SYST:COMM:LAN:AUTO ON
:SYST:COMM:LAN:AUTO?
Related
Commands
:SYSTem:COMMunicate:LAN:DHCP[:STATe]
:SYSTem:COMMunicate:LAN:MANualip[:STATe]