RIGOL Chapter 10 Waveform Record
10-8 DS2000E User’s Guide
Waveform Analysis
This function is used to analyze the recorded waveform. Press Utility Record
Mode and use to select "Analyze" to open the waveform analysis menu. At this
point, the screen is divided into two display areas as shown in the figure below.
Figure 10-3 Waveform Analysis
Please refer to the following explanations to set the waveform analysis parameters.
1. Analyze
Press Analyze to select the desired analysis mode.
Trace: perform analysis on the basis of the templet selected by users. For
the detailed information, refer to "Analysis Based on Trace".
Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by
users. For the detailed information, refer to "Analysis Based on
Pass/Fail Mask".
2. Source
Press Source to select the channel (CH1 or CH2) to be analyzed.
Note: Only currently enabled channels can be selected.
Settings and Results Templet Display Current Frame
To Next Page
Loading...
