Rigol DS2000E Series - Chapter 14 Remote Control

Chapter 14 Remote Control RIGOL
DS2000E User’s Guide
14-1
Chapter 14 Remote Control
The DS2000E oscilloscope can be controlled remotely through the following two
methods.
User-defined programming
Users can program and control the oscilloscope by using the SCPI (Standard
Commands for Programmable Instruments) commands. For more information about
the commands and programming, refer to the
DS2000E Programming Guide .
Use PC software
Users can use the PC software to send commands to remotely control the
oscilloscope. Ultra Sigma of RIGOL is recommended. You can download the latest
version of the software from RIGOL official website (
www.rigol.com).
This oscilloscope can communicate with PC through USB, LAN or GPIB (with the
USB-GPIB interface converter provided by RIGOL) instrument bus. This chapter will
give a detailed introduction of how to use Ultra Sigma to control DS2000E remotely
through various interfaces.
The contents of this chapter:
 Remote Control via USB
 Remote Control via LAN
 Remote Control via GPIB