27
Preparations
Setting the software DIP switches of the DPU-414
Turn on the power while holding down the ON LINE key of the DPU-414.
A printout showing the current status of the printer is produced.
An example showing suitable software DIP switch settings for use of the
printer with the VM-55 is shown below. (The actual printout will be in a
different font.)
[DIP SW setting mode]
Dip SW-1
1 (OFF) : Input = Serial
2 (ON) : Printing Speed = High
3 (ON) : Auto Loading = ON
4 (OFF) : Auto LF = OFF
5 (ON) : Setting Command = Enable
6 (OFF) : Printing
7 (ON) : Density
8 (ON) : 100 %
Dip SW-2
1 (OFF) : Printing Columns = 80
2 (ON) : User Font Back-up = ON
3 (ON) : Character Select = Normal
4 (ON) : Zero = Normal
5 (ON) : International
6 (ON) : Character
7 (ON) : Set
8 (ON) : =Japan
Dip SW-3
1 (ON) : Data Length = 8 bits
2 (ON) : Parity Setting = No
3 (OFF) : Parity Condition = Even
4 (OFF) : Busy Control = XON / XOFF
5 (OFF) : Baud
6 (ON) : Rate
7 (ON) : Select
8 (OFF) : = 19200 bps
For details, please refer to the documentation of the DPU-414.
To Next Page
Loading...
