Risco ProSYS 16 User Manual

ProSYS User's Manual 21
NOTE:
If you make a mistake, the keypad produces three short beeps. If so, press
quickly and re-enter the above sequence correctly.
3)
THE JONESES
ARM: EXIT = 0:45
THE JONESES
ARM: EXIT = 0:45
All persons are to exit except the person arming
the system. Leave the premises and close the
door.
The keypad beeps and the Arm/
LED flashes
while the system counts down the Exit Delay
time period (shown in the bottom right of the
LCD).
THE JONESES
ARMED
THE JONESES
ARMED
When the Exit Delay time period is up, the
Arm/
LED lights steadily.
Stay Arming
Stay arming activates only external detectors, enabling individuals to
remain inside and move about the premises even after the system is
armed.
¾ To stay arm:
1)
Check the Ready/
LED on your keypad. If it is lit or flashing, the
system is READY to be armed.
If the Ready/
LED is NOT lit or flashing, the system is NOT ready
to be armed. In this case, secure or bypass the violated zone(s), as
described on page 30, and then proceed.
2)
THE JONESES
05:42 DEC 16 TUE
THE JONESES
05:42 DEC 16 TUE
Hold the tag close to the keypad's keys or enter
your user code and press
/
.
NOTES:
Press / twice to cancel the Entry Delay time period.
Press during the Exit Delay time period to silence the beeps from the keypad.
If you make a mistake entering your user code, the keypad produces three short
beeps. If so, press quickly and re-enter the above sequence correctly.

Risco ProSYS 16 Specifications

General

Brand	Risco
Model	ProSYS 16
Category	Security System
Language	English