ProSYS User's Manual 71
FCC Compliance Section
FCC Part 15 Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
) Reorient or relocate the receiving antenna.
) Increase the separation between the equipment and receiver.
) Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
) Consult the dealer or an experienced radio/TV technician.
FCC Warning
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user's authority to operate the equipment.
FCC Part 68 Note (Telecom)
1) This equipment complies with Part 68 of the FCC Rules and the
requirements adopted by the ACTA. On the bottom panel of this
equipment is a label, that contains among other information, a product
identifier in the format US:RISAL10BMD2400. If requested, this
number must be provided to the telephone company.
2) This equipment is designed to be connected to the telephone network
using a terminal block, RJ31X or RJ 11. See Installation Instructions for
details.
3) A plug and jack used to connect this equipment to the premises wiring
and telephone network must comply with the applicable FCC Part 68
To Next Page
Loading...
Need help?
General
