56 ProSYS User's Manual
5)
SELECT USER:
00)0 GRAND
SELECT USER:
00)0 GRAND
Select the user to which you want to assign the
proximity tag and press
/ .
NOTE:
A display of (****) indicates that a user has already been assigned to a specific proximity
tag.
6)
USER XX: APPROACH
TAG TO UNIT
USER XX: APPROACH
TAG TO UNIT
Within 10 seconds, approach the proximity tag at a
distance of 3 to 7 cm. from the keypad's keys. The
keypad automatically reads the proximity tag and
saves it into the system's memory.
Once the proximity tag has been successfully
recorded, a long confirmation beep sounds, and a
confirmation message is displayed.
If the proximity tag is already stored in the system's
memory, the following message is displayed: USER
TAG ALREADY IN MEMORY.
NOTES:
Once a proximity tag is recorded, it will be functional from all keypads.
The programmed proximity tag has the same permissions that are defined for the
specified user code.
If a user is defined as having the Maid security level, then the proximity tag can operate
only if a security code was previously defined for that user.
Deleting a Proximity Tag By the User Serial
Number
You can use this option to delete a proximity tag for which the user is
known.
¾ To delete a proximity tag by user serial number:
1)
USER FUNCTIONS:
1) BYPASS
USER FUNCTIONS:
1) BYPASS
From the User Functions menu, select [5] Access
Code.
2)
INSERT CODE:INSERT CODE:
Enter your user code.
3)
ACCESS CODE:
1) UPDATE CODES
ACCESS CODE:
1) UPDATE CODES
Select [5] Prox Tag.
To Next Page
Loading...
Need help?
General
