52 ProSYS User's Manual
Chapter 11: Programming Function Keys
[*] [9] [CODE] [#] [5]
The ProSYS enables you to record a series of commands and assign them
to a Function key. When the Function key is pressed, the recorded
commands are executed from beginning to end.
NOTE:
The default function for all Function keys is group arming, as described on
page 24.
Before programming a Function key, it is recommended to perform your
required series of commands, making a note of every key you press while
doing so. These keys will be entered in the form of characters in step 4 of
the procedure for programming the Function key.
For example, to arm partitions 1 and 2 in a 3-partitioned system, you would
press the following keys in step 4:
CODE
/ /
This example requires the following sequence of characters:
1234a12a
NOTE:
Function keys cannot be programmed to perform disarming commands.
¾ To program a Function key:
1)
USER FUNCTIONS:
1) BYPASS
USER FUNCTIONS:
1) BYPASS
From the User Functions menu, select [9]
Miscellaneous.
2)
INSERT CODE:INSERT CODE:
Enter your user code.
3)
MISCELLANEOUS:
1) PRINTER CNTRL
MISCELLANEOUS:
1) PRINTER CNTRL
Select [5] Key Custom.
4)
CHOOSE KEY:
1) KEY A
CHOOSE KEY:
1) KEY A
The Choose Key menu lists the four function
keys. Select the function key that you want to
program.
5)
PRESS A TO
START/STOP
PRESS A TO
START/STOP
Press [A] (or the function key you selected in step
4).
To Next Page
Loading...
Need help?
General
