26 ProSYS User's Manual
Disarming
Disarming your system deactivates its detectors. Remember, fire protection
and the protection offered by the keypad's emergency keys are always
armed and always available.
Your ProSYS offers the following kinds of disarming:
) System, below
) Silencing an Alarm, page 26
) Partition, page 27
) Duress, page 28
) Fire Alarm, page 29
Disarming the System
Disarming deactivates all detectors in the system.
¾ To disarm the system:
1)
If outside the premises, open an "entry" door. The keypad(s) beeps,
indicating that the Entry Delay time period has begun.
2)
Before the Entry Delay time period expires, enter your user code and
press
/ .
NOTE:
If you make a mistake when entering your user code, the keypad will produce three
short beeps. If so, re-enter the sequence correctly.
Silencing an Alarm
The system is disarmed when an alarm is silenced.
¾ To silence an alarm:
1)
If outside the premises, open an "entry" door. The keypad(s) beeps,
indicating that the Entry Delay period has begun.
2)
Observe the keypad. If any of the following conditions is evident, an
alarm has occurred:
) For an LED keypad:
Y The Arm/
LED is flashing.
Y A Zone LED is lit steadily.
Y The Fire/
LED is lit steadily.
To Next Page
Loading...
Need help?
General
