ProSYS User's Manual 45
Chapter 10: Defining Weekly Schedules
[*] [6] [CODE] [#] [5]
Defining weekly schedules enables you to automate some system
operations. This is performed by defining up to two time intervals per day,
during which the system automatically performs one of the following
functions:
) Automatic Arming/Disarming, below
) Automatic UO Activation, page 48
) User Limitation, page 50
You can define automatic time intervals for every day of the week, or
individual days of the week. When performing this procedure, use the data
that you prepared in the table provided in Appendix C: Scheduling Tables,
page 70.
In some cases, it may be necessary to temporarily disable the automatic
scheduling. Each of the schedules contains an off/on parameter to quickly
perform this when needed.
Automatic Arming/Disarming
An arming schedule automatically arms and disarms the system during
your required time intervals.
When defining the automatic arming/disarming schedule, you need to
define the following parameters: On/Off, Partition, Arming Mode, Time,
and Label.
¾ To define an automatic arming/disarming schedule:
1)
USER FUNCTIONS:
1) BYPASS
USER FUNCTIONS:
1) BYPASS
From the User Functions menu, select
[6] Clocks.
2)
INSERT CODE:INSERT CODE:
Enter your user code.
3)
SET CLOCKS:
1) SYSTEM TIME
SET CLOCKS:
1) SYSTEM TIME
Select [5] Scheduler.
To Next Page
Loading...
Need help?
General
