ProSYS User's Manual 53
6)
KEY A CUSTOMKEY A CUSTOM
Use the numerical keys or the / key
to enter a series of characters representing your
required keys, as described on page 53. Each
character you enter is displayed in the second line
of the LCD.
7)
KEY A CUSTOM
1234a12a
KEY A CUSTOM
1234a12a
When you have finished entering the series of
characters, ensure that the cursor is placed in the
field after the last character in the series, and
press [A] (or the function key you selected in step
4) again. The series of characters is saved and
assigned to the selected function key.
NOTE:
When entering characters, ensure that the cursor is placed after the last character.
Otherwise, the last character you defined and everything after it will be erased, and the
Function key will not perform the required function.
8)
CHOOSE KEY:
1) KEY A
CHOOSE KEY:
1) KEY A
If required, select an additional Function key to
program and repeat the above procedure.
Using the Arm Key to Program Function Keys
In step 4 of the previous procedure, the
/
and
/
keys are used to toggle between and enter characters that represent keys
on the ProSYS keypad. The following is a list of these characters and the
keys they represent:
Character Represents
0-9
The Numerical keys from 0 to 9.
A-D
The Function keys from A to D.
a
The
/
key.
S
The
/
key.
To Next Page
Loading...
Need help?
General
