28 ProSYS User's Manual
For an LCD keypad, scroll with the
/ or the /
key to the required partition (or enter the partition's number).
3)
Press
/ to confirm. A confirmation message will be
displayed for several seconds.
4)
Repeat the above steps to disarm other partitions.
Examples:
) To disarm partition 3 with code 1234:
1-2-3-4
/ [3] /
) To disarm ALL partitions:
1-2-3-4
/ [0] /
) To disarm partitions 3 and 4:
1-2-3-4
/ [3] [4] /
NOTES:
ALL partitions relate to all partitions that are authorized by the security code in
use.
If the Arm / LED is flashing after disarming, check the display for activated
(alarmed) zones before proceeding.
Duress Disarming
If you are ever coerced into disarming your system, you can comply with
the intruder's wishes while sending a silent duress alarm to the Monitoring
Station. To do so, you must use a special duress code, which when used,
will disarm the system in the regular manner, while simultaneously
transmitting the duress alarm.
To use a duress code, add 1 to the last digit of your user code, as shown in
the table below:
User Code Duress Code
1-2-3-4 1-2-3-5
5-6-7-8 5-6-7-9
6-7-8-9 6-7-8-0
Under no circumstances must the duress code be used haphazardly or
without reason. Monitoring Stations, along with Police Departments, treat
duress codes very seriously and take immediate action.
To Next Page
Loading...
Need help?
General
