ProSYS User's Manual 27
) For an LCD keypad:
Y The Arm/
LED is flashing, and the display shows the disturbed
zone.
3)
Enter your user code and press
/ . If an alarm occurred,
the Arm/
LED and the corresponding Zone LED will flash for the
Alarm Memory period of about 60 seconds.
4)
If you are using an LCD keypad, scroll through the list of alarmed
zones.
5)
(Optional) To exit the Alarm Memory mode before the timeout has
expired, press
.
NOTES:
It is recommended to leave the premises. Only after police investigation should you
consider that the burglar is no longer on your premises and you can re-enter.
In special cases (if programmed so during installation), arming the system after an
alarm requires a technician code. On the LCD, a Not ready - technician reset
message will appear.
IMPORTANT:
If the alarm was caused by a tripped smoke detector(s), the keypad's Fire/ LED will remain
lit, providing an indication that the fire system must be reset before it will be capable of
detecting subsequent alarms. Furthermore, until it is reset, you will be prevented from arming
your system.
To reset a smoke detector, press [ ] [2] [2] [user code] [ / ].
Press [ ] [ ] to exit the User Functions mode.
Partition Disarming
Partition disarming enables you to disarm individual partitions within an
armed system.
¾ To disarm partitions:
1)
Enter your user code and press
/
.
2)
Select the partition number (1-8).
-OR-
To disarm all partitions at once, select 0.
-OR-
To Next Page
Loading...
Need help?
General
