ProSYS User's Manual 49
10)
UTIL OUTPUT S:02
01)OUTPUT 01 N
Specify whether or not the first UO in the list
should be automatically activated by using the
key to enter one of the following characters
at the end of the second line in the LCD:
Y: Automatically activated.
N: Not automatically activated.
11)
Specify whether or not the three remaining UOs in the list should be
automatically activated by selecting them and following step 7 above.
12)
UO ON/OFF S:02
2)UTIL OUTPUTS
Select [3] Day/Time.
13)
SELECT A DAY
1) MONDAY
SELECT A DAY
1) MONDAY
Define time windows for the week, as described in
step 16 on page 47.
14)
UO ON/OFF S:02
4)VACATION
Select [4] VACATION. In this option, you define
the way in which the group of UOs are activated
during a vacation.
15)
UO VACATION S:02
YES/NO N
N: During vacation, UOs are activated in the
same way as defined in the time windows of the
week. Go to step 20.
Y: UOs are activated during the vacation
according to the time schedule defined in the next
steps (vacation definition).
NOTE:
If all the time intervals during the vacation are defined as 00:00, then the UOs are not
activated during the vacation.
16)
VAC: START1 S:02
00:00
Enter the first time at which the UO is to be
activated on vacation.
17)
VAC: STOP1 S:02
00:00
Enter the first time at which the UO is to be
deactivated on vacation.
18)
VAC: START2 S:02
00:00
Enter the second time at which the UO is to be
activated on vacation.
To Next Page
Loading...
Need help?
General
