rletech.com WiNG-MGR User Guide 37
3 Web Interface
3.3. Wireless Network Metrics
This page shows the wireless network metrics for your sensors. RSSI and LQI metrics for the
system components can be found under the Wireless Network Metrics link in the left side
navigation.
These metrics are provided for advanced users with a strong knowledge of RF. You may also
need to provide them to your technician if you engage in a technical support call.
Figure 3.13
Wireless Network Metrics Page
Attribute Description
RSSI This is the Received Signal Strength Indicator. It represents the
received power of the signal. This number will always be a negative
value, and is provided for both channel pairs available for each
sensor.
To maximize the performance of this system, get the RSSI value as
close to zero as you can. If you are working to maximize this WiNG
system, the RSSI value will likely plateau close to -30. The closer
you can get your reading to -30, the better performance you’ll see.
Table 3.5
Wireless Network Metrics Field Descriptions
To Next Page
Loading...