rletech.com WiNG-MGR User Guide 41
3 Web Interface
Static Address The WiNG-MGR is shipped with a default IP address of 10.0.0.188.
Contact your IT Department for an appropriate IP address, if you
wish to change this field.
If you would prefer to use DHCP, set this field to 0.0.0.0 to enable
DHCPv4.
Default IP address: 10.0.0.188
Net Mask The WiNG-MGR is shipped with a default Subnet Mask of
255.255.255.0. Contact your IT Department for an appropriate
Subnet Mask, if you wish to change this field.
Default subnet mask: 255.255.255.0
Default Route The WiNG-MGR is shipped with a default Gateway Route of
10.0.0.1. Contact your IT Department for an appropriate Default
Gateway, if you wish to change this field.
Default device route: 10.0.0.1
Http Port Some ISPs use alternate http ports as an added security measure.
Edit this field in accordance with your ISPs security settings.
Default: 0 = Port 80
IPv6 Settings- Configure these fields if the WiNG-MGR is communicating via IPv6. You do
have the option in this section to use DHCP. If you do choose to enable DHCP, DHCP will
override any static options you configure.
DHCPv6 Click the Enable button to enable DHCP for IPv6.
Enabling IPv6 will override any static address information saved in
the IPv6 fields.
Static Address If you choose not to use DHCP, Enter a static IPv6 address in this
field.
Static Router Enter static router information here.
Prefix Length If the static address has a prefix, enter the bit length of the prefix
here.
Option Description
Table 3.7
IP Configuration Options
To Next Page
Loading...