c.
The program calculates the atmosphere
correction value, and return to normal
measurement screen. ※2)
d.
Press ON to activate the automatic
temperature and pressure sensor,
which will detect and fill the Temp and
Press automatically. ※3)
※ 1) The inputting scope: Temperature:-40 - +60°C (step length 0.1° C) or -40 - 140°F (step length 0.1°F)
Air pressure: 420 - 799.5mmHg (step length 0.1mmHg) or 560 - 1066 hPa (step length 0.1hpa)
16.5 - 31.5 inchHg (step length 0.1 inchHg)
※ 2) The atmosphere correction value will be calculated by the instrument according to the inputted temperature and pressure value.
3.3.3 Select Target Set
A target set specifies settings for the target type, the prism constant, and height of target.
When you change the selected target set, all the three settings are changed. You can use this function to
quickly switch between two types of targets, such as a reflecting sheet and a prism.
To select a target set, either press the corresponding numeric key (from 1 to 5), or use [▲]/[▼] to highlight
the target set in the list and press [ENT]. To change the settings defined in a target set, highlight the target
set in the list. Then press “Edit” softkey.
When a target set is selected, the Type and Const values are copied to both [MSR1] and [MSR2] settings.
If you have specified a value for HT, this value is also copied to the current HT.
a.
In Hot Key menu, press numeric key [3]
to enter target function.
To Next Page
Loading...