Rlide R2 Series - Hold Horizontal Angle

27
3.5.3 Repeat Angle Measurement
This program is used to accumulate repeated angle measurement, displaying the sum of and average
value of all observed angles. It records the observation times at the same time.
HR
X
=HR

 N
HA=BS
Z
A
+ HR
X
(normalized)
HR
X
is not updated even if the instrument is moved.
●In repeat angle measurement, the HA is replaced by HR

, and the number of repeat angles is
displayed (for example, N=6).
●Horizontal angles can be measured up to3599°59′59″.
●This function stores both raw and XYZ data as CP records.
STEP
OPERATION
DISPLAY
a.
In Angle menu press [3] to enter to the
repeat horizontal angle measurement
function.
[3]
Angle
HA: 273°13’45”
1.0SET
4.F1/F2
2.Input
5.Hold
3.Rept.
b.
System sets the initial value of HR as 0.
RePt.
N=00
HR∑
0°00’00”
HR
X
-HA HOLD-
* Sight BS
Press [ENT]
c.
Sight the first target point which is used
for repeat angle measurement. (i.e.
Backsight), and press[ENT]
Sight the
backsight
[ENT]
RePt.
N=01
HR∑
0°00’00”
VA:
79°42’26”
HD:
* Sight BS
Press [Meas]/[ENT]
d.
Use the horizontal clamp screw and
tangent to sight the second target point
(i.e. foresight), Here the horizontal angle
is accumulated.
To end repeat angle measurement,
press [ESC].
Sight the
foresight
RePt.
N=01
HR∑
46°03’48”
VA:
85°02’36”
HD:
* Sight FS
Press [Meas]/[ENT]