Rlide R2 Series - Quick Codes

28
e.
Press [ENT] to save the horizontal
angles. Screen returns to the initial
interface of repeat angle measurement.
Repeat steps c-e to proceed this function
as you need.
[ENT]
RePt.
N=01
HR∑
46°03’48”
HR
X
46°03’48”
-HA HOLD-
* Sight BS
Press [ENT]
When you have collected enough horizontal angle results, press [MSR1] or [MSR2] to take a
measurement to the foresight. The average horizontal angle is displayed. This value is fixed until the
process is finished or cancelled.
STEP
OPERATION
DISPLAY
a.
When you have accumulated enough
horizontal angles, you can take a
measurement to the foresight. First sight
the backsight and then press [ENT].
Sight the
Backsight
[ENT]
RePt.
N=03
HR∑
138°11’24”
HR
X
46°03’48”
-HA HOLD-
* Sight BS
Press [ENT]
b.
Sight the foresight，press [MSR1] or
[MSR2] to start surveying.
Sight the
foresight
[MSR1]/
[MSR2]
RePt.
N=03
HR∑
138°11’24”
VA:
85°02’36”
HD:
* Sight FS
Press [Meas]/[ENT]
c.
Display the measuring result.
RePt.
N=03
HR
X
46°03’48”
HA#
46°03’48”
HD:
* Press [ENT] Rec
Press [Meas]/[ENT]
Press [ENT] to record.
[ENT]
3.5.4 Face-1/Face 2 Measurement
Using F1/F2 measurements effectively cancels out mechanical constant error to obtain maximum
accuracy for measuring angles. To take F1/F2 data without taking a distance measurement, press
[ANG]→[4] to select F1/F2 in the Angle menu.
For the HA to be adjusted from a F1/F2 measurement, the Backsight must also have been measured in
F1/F2 during the station setup.