Rlide R2 Series - Page 36

34
e.
After Measuring, the result is displayed
as showed in the right graph. ※2)
A：
To determine the backsight point only by
F1，press [ENT] to end measuring.
B1：
To determine the backsight point by
F2，press [F2] softkey. As showed in
B1.
B2：
To go directly to the Face-2
measurement after taking a distance
measurement to the BS on Face-1, flip
the telescope. ※3)
Sight the backsight point, press [MSR1]
or [MSR2] to start F2 measurement,
press [ENT] after measuring. If no need
to measure, just press [ENT]. ※2)
A：
Stn Setup
1/2
AZ:
30°21’50”
HD#
2.178m
SD#
2.186m
* Press [ENT] End
F2
B1：
Stn Setup
1/2
AZ:
30°21’50”
* Turn to F2
* Press [ENT] End
F2
B2：
Stn Setup
1/2
AZ:
0°00’00”
HD#
SD#
* Use F2 Obs.BS
* Press [MSR]/[ENT]
f.
Press [DSP] to display a QA screen.
(Quality Assessment)
To record a CP record which stores the
averaged HA, VA, and SD from the
F1/F2 data, press the
[CP] softkey. To record only the ST and
F1/F2 records, without a CP record,
press the [OK] softkey. Press [Abrt] to
return to procedure
Stn Setup
1/2
dHA:
0°00’05”
dVA:
-0°00’01”
dSD:
0.001m
* Press [ENT] End
Abrt
CP
OK
g.
Procedure records the station and raw
data to current job and finish setting up
station. Screen returns to BMS.
Display
2/5
AZ#
20°00’00”
HD#
SD#
PT:1
HT:
1.000m
※1) AZ：Azimuth calculated by coordinates.
※2) Press [▼] or [DSP] to switch QA screen (dHD/dVD)。
dHD/dVD: indicates the difference between the measured distance and the distance calculated from the
known coordinates.
※3) The instrument automatically detects F1/F2.