Rlide R2 Series - Stakeout Functions; Stake Out Angle and Distance

44
h.
Press [F2] and Rotate the telescope and
alidade, and sight the center of target
prism. Press [MSR1] or [MSR2]. If not
measure on F2, press [ENT] and
proceed to Step j.
Rotate the
telescope
+
[MSR 1]/
[MSR 2]
Level point
HA#
175°17’18”
VD#
HD#
* Sight Press [MSR]
i.
After finishing measurement on F2, the
result is displayed, press [ENT].
[ENT]
Level point
HA#
175°17’18”
VD#
-0.306m
HD#
1.959m
* Press [ENT]
F2
j.
The result dialog box is displayed, press
[OK] to confirm.
To remeasure, press [Abrt].
[OK]
or
[Abrt]
Stn Setup
dHA:
0°00’00”
dVA:
-0°00’02”
dSD:
0.001m
* Press [ENT] Rec
Abrt
CP
OK
k.
The updated station coordinates are
displayed, the height Z is updated. You
can change the HI in this screen.
N:
10.000m
E:
10.000m
Z:
6.180m
ST:
1
HI:
1.600m
l.
Press [ENT] to record the updated STN.
Screen returns to Stn Setup menu.
[ENT]
Stn Setu
1. Known
2. Rese
3. QuickStn
4. Z Coord
5. BS Check
※1) About method to input PtID, please refer to “2.8 METHOD TO INPUT PTID”.
When the HI is changed, the Z coordinate is updated before the station is recorded.
You must complete a station setup before you use the Height Transfer function.